Home > HVAC Components > ICM 3-Phase Voltage Monitor ICM400

ICM 3-Phase Voltage Monitor ICM400

Stop Motor Burnouts!
High performance, low cost model, front and back side protection, 7 bright fault LEDs, integral short-cycle protection, easy setup, fully adjustable features, 190-630 VAC...
The ICM400 was specifically designed to protect motors and other 3-phase loads from premature failure and damage due to common voltage faults such as voltage unbalance,
over/under voltage, phase loss, reversal, incorrect sequencing and rapid short cycling.
3-Position Reset Switch, 50/60 Hz
• Choose from 3 easy-to-select reset modes:
• Full manual
• Full automatic
• Auto front/manual back
• Frequency: 50/60 Hz
• Bright LED’s show modes and identify faults:
Load energized LED
Control voltage LED
Lockout LED
Front fault LED
Back fault LED
High voltage LED
Low voltage LED
• Knob-adjustable variables...user may easily
• select and adjust setpoints on unit:
• Voltage unbalance: 2–25%
• Delay on break period: 1–5 min.
• Fault interrogation: 1–15 sec.
• Line voltage: universal- 190-630 VAC
• Frequency: 50/60 Hz
Contactor Load Side (Back)
• Line voltage: universal- 190-630 VAC
Load side monitoring is optional.
• Type: relay
• Voltage range: 240 VAC (max: 10 amps)
Control Operating Temperature
• Operating temperature: -40° to +75°C, -40° to 167°F
• Storage temperature: -40° to +85°C, -40° to 185°F
Phase Unbalance Protection Voltage unbalance: 2-25% adjustable
Over/Under Voltage Protection
• Under/over voltage: fixed at 12%
• Hysteresis: 6%
• Low cost, high performance...full line protection and fault
identification without costly LCD readout
• Integral delay on break timer...knob-adjustable from 1-5 min., helps
prevent rapid system recycling
• Easy to install and configure... wiring diagram on unit, installation
and application guide included
Phase Loss Protection Phase loss condition
= <25% of nominal for any given phase. System will shut down and a
fault will be recorded should this condition occur.
Delay on Break Timer: Time delay: 1–5 min. adjustable
Fault Interrogation Delay
• Time delay: 1-15 sec. Adjustable
• Provides a delay between fault detection and system shutdown,
eliminating nuisance trips/ unnecessary shutdowns.
• Mounting: surface mount using (2) #8 screws
• Terminations: screw terminals
• Weight: 12 ounces (341 grams)
• Dimensions: 6.5” x 4.25” x 1.4”
Sort By:
Page of 1
Usually Ships in 2 to 3 Business Days

Our Price: $191.53
Sale Price: $148.32
Savings: $43.21